I just installed a SWM8 with my slimline 5lnb and when the dvr (HR22) does its setup it list problems with some satellites. I haven't noticed any missing channels, but am not sure if something is wrong. Here is the info from the signal meter and test channels. Dish was installed by DirecTV.
I have a simple install. 4 Dish cables and 1 OTA to SWM, one to PI, duplexer after PI, to DVR and TV. One cable from legacy port to a DirecTivo.
In setup I set it to the 5LNB and switch type is SWM.

Should I have 0 for any transponders?
How can I find what channel is on what sat/transponder to check if it is coming in correctly?
Are all the N/A transponders that are not active?
How come the test channel for 101 would not show the correct setup message, but the signal strength is good for all transponders?


Any information would be appreciated, or please point me to where the answers are.
Thank you

Test Channels

these show a correct setup message

9506 99B Odd
9507 99B Even
9508 103A Odd
9509 103A Even
9510 103B Odd
9510 103B Even

these just show the test message

9501 101
9502 101
9512 110
9513 119
9514 119


Here are the signal meter results
(any transponder not shown had N/A)


SWM

1-8 90-98 signal
9 89
others NA

sat 99s 99c

1 0 1-14 in the 80's
2 77
3 0
4 0
5 0
6 72
15 0
16 60
17 66
18 51
19 58
20 62
21 61
22 69
23 0
24 0


sat 101

all transponders show good signal 90's



103s 103ca 103cb

1-6 0 9-16 70's 1-8 86-95
15 88 17-24 68-72 9-14 88-90
16 86
17 51
18 67
19 89
20 89
21 63
22 64
23 87
24 89

others NA

sat 110

8 84
10 92
12 84

sat 119

22 95
23 0
24 87
25 96
26 95
27 91
28 92
29 85
30 95
31 0
32 95