Tweet
I have tried all 24 combinations and the satalite setup screen gives me a different pattern of X's and Checks for each one, but none of them seem to work.
The wiring diagram seems simple, but I must not have somthing configured correctly.
4-wires from dish to SWM-8 (Does order matter?)
1-wire from SWM/PWR on SWM-8 to SWM
1-wire from SWM on SWM Multi-Switch
1-wire from IRD on SWM Multi-Switch to HR20-700 Satalite In #1
No B-Ban Converter
No wire into Satalite In #2
Select Slimline LNB5 as dish type
(How do I know if this right, or if it is Slimline (SWM)?
Select SWM as Switch Type
(This is not a choice, it auto selects this for me)
Test screen shows some combinations of Satalite and 18v vs. 13v working and some combinations of 18v vs. 13v not working.
It always says there were errors on both receivers and that I should check my configuration and re-test.
I change the order of the wires from the dish to the SWM-8 and retest and usually get a different combination of things that work and don't work, but never get them all checked.
Thank you in advance for any suggestions.
Bill.
The wiring diagram seems simple, but I must not have somthing configured correctly.
4-wires from dish to SWM-8 (Does order matter?)
1-wire from SWM/PWR on SWM-8 to SWM
1-wire from SWM on SWM Multi-Switch
1-wire from IRD on SWM Multi-Switch to HR20-700 Satalite In #1
No B-Ban Converter
No wire into Satalite In #2
Select Slimline LNB5 as dish type
(How do I know if this right, or if it is Slimline (SWM)?
Select SWM as Switch Type
(This is not a choice, it auto selects this for me)
Test screen shows some combinations of Satalite and 18v vs. 13v working and some combinations of 18v vs. 13v not working.
It always says there were errors on both receivers and that I should check my configuration and re-test.
I change the order of the wires from the dish to the SWM-8 and retest and usually get a different combination of things that work and don't work, but never get them all checked.
Thank you in advance for any suggestions.
Bill.
Comment