Tweet
Should the Dish Type be set to 04:Slimline-5 or 18:Slimline-5S(SWM)
-for example-
when setting the Switch Type to 01:SWM ?
-for example-
when setting the Switch Type to 01:SWM ?
-
-
When using a SWM8 multiswitch, the dish is set to Slimline-5, NOT 5S(SWM) -
Same with SWM5?
Is this also true of SWM5? I've only used 8's before, so not being dense...
BTW - Many thanks for your prompt response - you da man!Comment
-
Actually I am Dense.
Dish config = Slimline 5
Switch = SWM (rather than multiswitch)
Correct?Comment
-
That is correct.Comment
-
hello,
i have an hr22 and and h25-500.
i have a slimline 5 and 95
i have the sw8 and a PI
i believe i hooked everything up ok since i can view the signals on the signal meter for all satellites on both receivers and can watch tv.
what i dont understand is on the verifying configuration screen which shows an red x for 95 on odd and 2 red Xs for 103 both odd and even?
did i do something wrong? what does this mean?
should i tweak the dish or rewire some things?
hope someone can help
Comment
-
Originally posted by rwny1 View Posthello,
i have an hr22 and and h25-500.
i have a slimline 5 and 95
i have the sw8 and a PI
i believe i hooked everything up ok since i can view the signals on the signal meter for all satellites on both receivers and can watch tv.
what i dont understand is on the verifying configuration screen which shows an red x for 95 on odd and 2 red Xs for 103 both odd and even?
did i do something wrong? what does this mean?
should i tweak the dish or rewire some things?
hope someone can help
first thing ... be sure to have the 95 on flex port 1 .... also check the transponders on the 103 & see that they are all above 88... lyngsat shows l & r polarities on the 95 ...so not sure about it ... but just check & see on the signals there too.... sometimes i have seen the x in error with good signal ... if all your channels come in & everything works ... i wouldnt worry about itComment
-
thanks for the response...
after a few hours on the roof switching out wires and switching out switches and switching out the lnb and constant checking of the verifying configuration, i still had the red x's
i gave up and decided to try to get get signal levels of the 95 and 99 and 103 up to as high as i could get...after getting near or above 90s...and verifying the configuration again, it was successful...
so i guess i got the error message due to low signal strength...Comment
Comment