Tweet
I have followed the below instructions posted for putting my Bolt into Kickstart mode:
I used kickstart code 54 and I get the alternating green and amber lights, but in the end it just starts up normally. What am I doing wrong? Has anyone successfully run kickstart 54 on a Bolt?
1. If your Roamio remote control is in RF mode, you will need to put it in IR mode before running the kickstart procedure. Press TiVo + C to enter IR mode.
2. As the TiVo DVR restarts, the green LED light on the front bezel of the box will be lit.
3. When you see the yellow/amber light begin to flash, wait a second and then press and hold the Pause button on the remote for two seconds, then release it.
4. Within 5 seconds, press the kickstart code (see below) on the remote control.
5. If you are successful, the green and amber lights will blink in alternating patterns to indicate the code has been accepted.
2. As the TiVo DVR restarts, the green LED light on the front bezel of the box will be lit.
3. When you see the yellow/amber light begin to flash, wait a second and then press and hold the Pause button on the remote for two seconds, then release it.
4. Within 5 seconds, press the kickstart code (see below) on the remote control.
5. If you are successful, the green and amber lights will blink in alternating patterns to indicate the code has been accepted.
I used kickstart code 54 and I get the alternating green and amber lights, but in the end it just starts up normally. What am I doing wrong? Has anyone successfully run kickstart 54 on a Bolt?
Comment