I just received back a TIVO Bolt returned to WK for a defective internal hard drive. I purchased an external hard drive and followed the provided setup instructions.
1) With the external drive running, I applied power to the TIVO. I briefly saw the TIVO logo on my TV screen, then all LEDs started flashing and I got the 'no signal" message on my screen.
2) After about 30 seconds of flashing LEDs, I removed power to the TIVO; leaving the external hard drive running.
3) After 3 - 4 minutes, I re-applied power to the TIVO.
4) All I see now is the "no signal" message on the TV screen. No LEDs show up on the TIVO.
5) I did try pressing the "TIVO" button on my remote in case the TIVO was asleep. Still no luck.
Suggestions?
1) With the external drive running, I applied power to the TIVO. I briefly saw the TIVO logo on my TV screen, then all LEDs started flashing and I got the 'no signal" message on my screen.
2) After about 30 seconds of flashing LEDs, I removed power to the TIVO; leaving the external hard drive running.
3) After 3 - 4 minutes, I re-applied power to the TIVO.
4) All I see now is the "no signal" message on the TV screen. No LEDs show up on the TIVO.
5) I did try pressing the "TIVO" button on my remote in case the TIVO was asleep. Still no luck.
Suggestions?
Comment