Announcement

Collapse
No announcement yet.

Afer Upgrade Series 2 - no response to hand unit at initial screen

Collapse
X
Collapse
 
  • Page of 1
  • Filter
  • Time
  • Show
Clear All
new posts
Previous template Next
  • #1

    Afer Upgrade Series 2 - no response to hand unit at initial screen

    I completed an upgrade - which I'm pretty sure I had done correctly, as I followed the directions and had swaped hard drives onto PCs before - connected everything and get the very initial screen prompting me to push the "select" to continue and no response from the button when pressed.

    The red light is steady and I know the hand held is still good, any help would be appreciated.

    Thanks in advance,
    Duker
    Tags: None
  • #2
    There's a very, very sensitive white ribbon cable that goes from the motherboad to the front panel of the unit. If you boot the unit with that cable even partially dislodged, you can cause temporary or permanent damage to the ability for remotes and buttons to work. Open the unit back up and check the cable - if you see any silver of the contacts, then you've most likely found the problem.D
    Been here a long time . . .

    Comment

    • #3
      Michael,

      Thanks for the quick response - must have knocked this wire during installation. Setting up now and the unit is responsing to the hand held commands.

      Thanks again,
      Duker

      Comment

      • #4
        Glad to hear it. Consider yourself lucky. Often, the damage is permanent.
        Been here a long time . . .

        Comment

        Previous template Next
        Working...
        X