Tweet
Just moved to a new house. Had a new slimline 5 LNB dish installed, Satellite USA wide-band multiswitch too. (WBS41602NF)
Problem - all four feeds off the dish are good. I hook-up the multiswitch and all feeds from multiswitch are good using an old SD Hughes sat receiver to test each port. Hook up my three HR10-250s and get nothing. No signal, either input.
All cabling is new and all test fully OK. Signal loss is not an issue. 25 feet of cable from dish to multiswitch, longest run in house is just over 100 feet.
I hook up two of the HR10-250s straight to the dish using the same cabling and get great signal and picture on both inputs on both receivers. Hook the multiswitch back up and get nothing. No signal to any input.
DTV said I need B-Band converters for all HR10-250 inputs. OK, get them and install them. Same situation. Receivers work fine off the dish, don't work through multiswitch.
Again - the multiswitch works fine on all outputs to my single input SD receivers.
Any ideas?
Thanks!
Problem - all four feeds off the dish are good. I hook-up the multiswitch and all feeds from multiswitch are good using an old SD Hughes sat receiver to test each port. Hook up my three HR10-250s and get nothing. No signal, either input.
All cabling is new and all test fully OK. Signal loss is not an issue. 25 feet of cable from dish to multiswitch, longest run in house is just over 100 feet.
I hook up two of the HR10-250s straight to the dish using the same cabling and get great signal and picture on both inputs on both receivers. Hook the multiswitch back up and get nothing. No signal to any input.
DTV said I need B-Band converters for all HR10-250 inputs. OK, get them and install them. Same situation. Receivers work fine off the dish, don't work through multiswitch.
Again - the multiswitch works fine on all outputs to my single input SD receivers.
Any ideas?
Thanks!
Comment